Kenwood DP-1100 B Service Manual page 152

D P - 1 1 0 0 B II
5 - 3 - 4 R e p l a c e m e n t of loading motor on loading gear group
R e m o v e s c r e w (3) ( M 2 . 6 x 6 )
m o u n t so t h a t overall c l a m p e r lever m o u n t a s s ' y ( 8 1 4 ) c a n
m o v e freely.
R e m o v e s c r e w ( 1 1 ) ( M 2 . 6 x 1 2 ) m o u n t i n g the m e c h a n i s m
chassis so t h a t t h e overall m e c h a n i s m chassis ass'y c a n m o v e
freely.
Note: When removing screw (11), be careful not to damage the lead wire
(brown) of leaf switch (S001) in overall clamper lever mount ass'y
(814).
R e m o v e gear s u p p o r t w a s h e r ( 6 5 ) ( 0 2 . 1 ) , a n d gear B ( 6 6 ) ,
gear C ( 6 7 ) , gear A ( 7 0 ) , gear E ( 6 8 ) a n d gear E ass'y (69)
will be d e t a c h e d in t h a t order. W h e n r e m o v i n g gear A ( 7 0 ) ,
slightly raise m e c h a n i s m chassis a s s ' y ( 8 0 3 ) .
Note: Take special care in removal of gears, since gear A (70) is extremely
susceptible to damage. When removing gear E (68), be careful not
to break a gear leg in opening it with tweezers as shown.
R e m o v e s c r e w ( 7 1 )
loading m o t o r , a n d loading m o t o r a s s ' y ( 7 4 ) will be d e t a c h ­
e d .
Desolder t h e t e r m i n a l section of l o a d i n g m o t o r ass'y ( 7 4 ) .
A s s e m b l y s h o u l d be carried o u t in the reverse p r o c e d u r e .
Notes: • When putting in gears, be careful not to damage them. Especial­
ly, as gear A (70) is susceptible to damage, take adequate care
in removal work.
• When mounting the loading motor by screw (71), avoid applica­
tion of excessive turque to the screw, as this may cause a
broken thread.
• When replacing the loading motor or resoldering it, pay attention
to motor polarities. As shown in Fig. M26-B, the hole section in
the panel side is the specified soldering point and motor moun­
ting location.
156
5. MECHANISM OPERATION
m o u n t i n g the c l a m p e r lever
( M 2 . 6 x 3 . 5 , black) m o u n t i n g
(1) Gear B (66)
(3) Gear A (70)-
the
Fig. M 2 6 R e p l a c e m e n t of loading gears
Gear support washer (65)
(2) Gear C (67)
(4) Gear E (68)
(5) Gear D (69)
Hole section
Fig. M 2 6 - B