Kenwood DP-1100 B Service Manual page 142

D P - 1 1 0 0 B II
b) T r a y drive rack (80) is driven by gear C ( 6 7 ) of the
l o a d i n g gear g r o u p so t h a t t h e tray (ass'y) is retracted
into t h e unit. (Fig. M 5 )
c) W h e n the tray nears the position at w h i c h it is h o u s e d ,
c l a m p e r gear ( 5 3 ) starts rotating by m e a n s of the u p ­
per rack s e c t i o n of c l a m p rack ( 8 2 ) . C l a m p rack (82)
is pressed in t h e inside of its l o n g hole by s t e p p e d
s c r e w ( 7 8 ) to m o v e at the s a m e s p e e d as drive rack
( 8 0 ) . (Fig. M 6 )
Clamper gear (53)
Lock lever (813)
5. MECHANISM OPERATION
Drive rack (80) Idle rotation
Gear E (68)
Gear D ass'y (69)-
Loading motor ass'y (74).
Fig. M 5 Loading gear motion a n d drive rack driving (2)
Engagement begins.
Stepped screw (78) is in hole of clamp rack (82).
Clamp rack (82)
_Stepped screw (78)
Gear E (68)
Gear D ass'y (69)
. T r a y reinforcement plate
Lock pin
Loading motor ass'y (74)-
Fig. M 6 Relative operation b e t w e e n drive rack and c l a m p rack (1)
Gear C engages drive rack.
• Gear B (66)
Gear A (65)
.Clamp rack (82)
Drive rack (80)
Engagement is about to end.
Gear C (67)
Gear B (66)
Gear A (65)