Power Supply Replacement - Philips VL1000 TS Service Manual

VARI❋LITE® - VL1000™ ERS L

Power Supply Replacement

Parts:
POWER SUPPLY, 130W +24V/6.3A (69.3177.0151)
Tools:
#1 Phillips screwdriver, 5/16 inch nutdriver
To remove and replace power supply:
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. Remove yoke leg cover (side without menu display) by removing four 6-
Step 3. At power supply, disconnect all connectors.
Step 4. Loosen two 4-40x1/2" PPZ screws and remove one 4-40x1/2" PPZ screw. Remove
Step 5. Replace LVS. Reconnect all cables as follows:
To Dimmer Module
44
S
UMINAIRE ERVICE
32x3/8" PTB screws as shown in
power supply.
LVS
Red Wire (24VDC)
Figure 2-22: VL1000 Low-Voltage Supply (LVS)
14-May-2009
M
ANUAL
Figure 2-23.
Dimmer to LVS Cable Assembly
(part number 25.9663.2826)
(TD, TID, TSD models Only)
White Wire (AC Neutral or ACN)
Black Wire (AC Line or ACL)
Stack Connections
AC Input Cable Assembly
Green/Yellow Wire (Ground)
Black Wire (24VDC)
25.9663.2826 will connect
to ACN and ACL as indicated.
as Shown
02. 96 63. 001 0 F