Philips VL1000 TS Service Manual page 49

Step 2. If applicable, lower gobo wheel into place over rotating shaft, fitting wheel
Step 3. Orient gobo wheel so that notch of gobo wheel gear aligns with small ridge
Step 4. Re-check alignment of clock mark with groove of index gear. Adjust as
Gobo Wheel
Pivot Mechanism
(automatically sets
belt tension)
Align ridge in belt with
notch in gobo wheel gear
02. 96 63. 001 0 F
position belt around lower gear and index timing belt around top gear. Install
4-40x1/4 " PPZ screw, split lock washer, flat black washer and flat Teflon
washer to secure gobo wheel in place. (Belt tension is automatically set by
springs of pivot mechanism.)
found on index timing belt.
necessary until marks are perfectly aligned at both gears.
4-40x1/4 " PPZ screw
Split Lock Washer
Flat Black Washer
Teflon Washer
Figure 2-11: Aligning Second Clock Mark
14-May-2009
Wheel Position Gear
Gobo Wheel Gear Notch
Rotating Gobo Bulkhead Crossview
2
M :
AINTENANCE
Wheel Position Belt
(no alignment)
Index Gear
Index Timing Belt
(gray for clarity)
31