Ignitor Pcb Replacement - Philips VL1000 TS Service Manual

Ignitor PCB Replacement

Note: This procedure not applicable to all units.
Parts:
PCB ASSEMBLY, IGNITOR (24.9661.3126)
Tools:
#2 Phillips screwdriver
To remove and replace ignitor PCB:
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. Remove yoke leg cover (side without menu display) by removing four 6-
Step 3. At ignitor PCB, disconnect lamp connectors.
Step 4. Remove four 6-32x3/8" PPB screws and remove ignitor PCB.
Step 5. Replace ignitor PCB by doing steps 2 through 4 in reverse.
02. 96 63. 001 0 F
32x3/8" PTB screws as shown in
NOTE:
Head not shown for clarity.
Ignitor PCB
6-32x3/8" PPB Screw
Figure 2-21: Ignitor PCB Replacement
14-May-2009
M
Figure 2-21.
6-32x1/2" PPB Screw
2
:
AINTENANCE
Yoke Leg Cover
6-32x3/8" PPB Screw
43