1. Manuals
  2. Brands
  3. U.S. Products Manuals
  4. Floor Machine
  5. COBRA-300H
  6. Operating instructions manual

U.S. Products COBRA-300H Operating Instructions Manual

Extractor 100v
Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
IMPROPER USE OF THE MACHINE WILL VOID THE WARRANTY
1. Always use a defoamer when foaming occurs to prevent vacuum motor damage.
2. Keep machine from rain and snow, extremes in temperatures, and store in a
heated location. Use the machine indoors. Do not use outdoors.
3. Do not let the pump run dry.
4. Use approved chemicals only. NO SOLVENTS.
5. Wear gloves or use rags when removing quick disconnects to prevent burns.
6. Never use water above 54º C/130º F in the solution tank.
COBRA
EXTRACTOR
100V
DO NOT OPERATE MACHINE UNTIL YOU HAVE READ
ALL SECTIONS OF THIS INSTRUCTIONS
-300H
®
INFORMATION
OPERATING
INSTRUCTIONS
&
03/10 revised 11/11 FORM NO. 56041891

Advertisement

Table of Contents
loading

Related Manuals for U.S. Products COBRA-300H

Summary of Contents for U.S. Products COBRA-300H

  • Page 1 COBRA -300H ® EXTRACTOR 100V INFORMATION & OPERATING INSTRUCTIONS DO NOT OPERATE MACHINE UNTIL YOU HAVE READ ALL SECTIONS OF THIS INSTRUCTIONS IMPROPER USE OF THE MACHINE WILL VOID THE WARRANTY 1. Always use a defoamer when foaming occurs to prevent vacuum motor damage. 2.

  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS This machine is only suitable for commercial use, for example in hotels, schools, hospitals, factories, shops and offi ces other than normal residential housekeeping purposes. When using any electrical appliance, basic precautions should always be followed, including the following: NOTE: Read all instructions before using this machine.

  • Page 3: Cleaning Solutions

    INSPECTION: Carefully unpack and inspect your COBRA-300H for shipping damage. Each machine is tested and in- spected before shipping. Any shipping damage incurred is the responsibility of the carrier. You should notify the carrier immediately if you notice damage to the box or to the machine or parts.

  • Page 4: Switch Plate

    SWITCH PLATE UPHOLSTERY PUMP CARPET VACUUM (1), PUMP (2)SWITCHES: These switches are powered by cord #1. Switches light up when turned on. CARPET/UPHOLSTERY SWITCH (3): This switch is also powered by cord #1. The carpet setting (down position) is high pressure (approximately 300 PSI).

  • Page 5: Troubleshooting

    SET-UP: Fill the holding tank with clear water and the detergent of your choice. Mix well. Although this machine is designed to supply instant hot water, the addition of warm water (not exceeding 54º C/130º F) to the holding tank will increase the effi ciency of the heater. Plug in cord #1.
  • Page 6 revised 11/11 FORM NO. 56041891 - 6...
  • Page 7 2061 Mount Plate, Pump Motor Louver, 3” (includes screws) 105USP Reducer Nipple, Brass 909A Latch Strike, for Latch, S/S FP238 Bypass Valve, Complete for Cobra-300H 45USP Quick Disconnect, 1/4 n.p.t. Hose Barb 115USP Washer, Fiber FP169E Hose, 3/8” X 8”...
  • Page 8 425-322-0133 / 800-257-7982 / FAX: 425-322-0136 11015 - 47th Ave. W. / Mukilteo, WA 98275 VISIT US AT: http://www.usproducts.com...

Table of Contents