U.S. Products PB111-120 Operating Instructions Manual

U.S. Products PB111-120 Operating Instructions Manual

The ultimate: pb111 extractor

Advertisement

Quick Links

INFORMATION AND
OPERATING
INSTRUCTIONS
MODELS: PB111-120, PB111-120-DZ, PB111-120-S,
PB111-120-B, PB111-120-SP, PB111-120-SS,
PB111-240
CAUTION: DO NOT OPERATE MACHINE UNTIL YOU HAVE READ
1.
Never use the Booster Heat when solvent is in the machine.
2.
Never attempt to heat solvent above 130 °F.
3.
Always use a nonfl ammable solvent with a fl ash point of 140 °F or higher.
Even solvents with a fl ash point above 140 °F can be ignited, especially as an aerosol from the wand.
4.
The recovery bucket should be emptied each time the holding tank is fi lled.
5.
Always make sure the fl oat travels freely up and down the rod after emptying the recovery bucket.
6.
Always vacuum out the stainless steel tank and solution lines when switching from a solvent to a
water based detergent, and vice versa (see Operating Instructions).
7.
Always use a drop cloth under the machine during operation.
8.
Vacuum any unused solution out of the solution tank and empty the recovery bucket after each job.
9.
Keep machine from rain and snow, extremes in temperatures, and store in a heated location.
Use the machine indoors. Do not use outdoors.
10. Do not run the pump dry.
11. Never operate a machine that is leaking or in need of a repair.
12. Always use a defoamer. The vacuum shut-off will not activate properly if foam is in the recovery
bucket. Water damage to the vacuum motor or other components will void the warranty.
If you have any questions before you operate the machine, call your supplier for instruction.
THE ULTIMATE: PB111
EXTRACTOR
ALL SECTIONS OF THIS INSTRUCTION MANUAL
IMPROPER USE OF THE MACHINE WILL VOID THE WARRANTY
DO NOT SMOKE WHEN USING HYDROCARBON-BASED SOLVENTS.
12/10 revised 5/14 FROM NO. 56041875 REV B

Advertisement

Table of Contents
loading

Summary of Contents for U.S. Products PB111-120

  • Page 1 THE ULTIMATE: PB111 EXTRACTOR INFORMATION AND OPERATING INSTRUCTIONS MODELS: PB111-120, PB111-120-DZ, PB111-120-S, PB111-120-B, PB111-120-SP, PB111-120-SS, PB111-240 CAUTION: DO NOT OPERATE MACHINE UNTIL YOU HAVE READ ALL SECTIONS OF THIS INSTRUCTION MANUAL IMPROPER USE OF THE MACHINE WILL VOID THE WARRANTY Never use the Booster Heat when solvent is in the machine.
  • Page 2: Cleaning Solutions

    A - ENGLISH INSTRUCTIONS FOR USE revised 6/12 INTRODUCTION This manual will help you get the most from your equipment. Read it thoroughly before operating the machine. This product is intended for commercial use only. PARTS AND SERVICE Repairs, when required, should be performed by your Authorized Service Center, who employs factory trained service personnel, and maintains an inventory of original replacement parts and accessories.
  • Page 3: Important Safety Instructions

    revised 6/12 INSTRUCTIONS FOR USE ENGLISH - A IMPORTANT SAFETY INSTRUCTIONS This machine is only suitable for commercial use, for example in hotels, schools, hospitals, factories, shops and offi ces other than normal residential housekeeping purposes. When using any electrical appliance, basic precautions should always be followed, including the following: NOTE: Read all instructions before using this machine.
  • Page 4 A - ENGLISH INSTRUCTIONS FOR USE revised 5/14 120VAC GROUNDING INSTRUCTIONS This appliance must be grounded. If it should electrically malfunction, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment-grounding conductor and grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
  • Page 5: Maintenance

    revised 6/12 INSTRUCTIONS FOR USE ENGLISH - A SET-UP: Make sure the recovery bucket is in place under the dome and in the correct position. The dome must be fl at or it won’t seal properly. Fill the stainless steel holding tank with cleaning solution, to the desired level. Solution must be at least 3” above the fi lter in the bottom of the tank.
  • Page 6 A - ENGLISH INSTRUCTIONS FOR USE revised 6/12 VACUUM WARNING INDICATOR PUMP HEAT BOOSTER HEAT SOLVENT HEATING Turn on the Heater Switch (D). The Booster Heat switch (E) must be all the way off (turned counterclockwise until it ‘clicks’ off) or the machine will not heat at all.
  • Page 7: Specifications And Features

    revised 6/12 INSTRUCTIONS FOR USE ENGLISH - A SPECIFICATIONS AND FEATURES: Construction: Stainless steel and hexane copolymer for use with solvents and water based detergents Vacuum: 80” water lift - 97 CFM Heat Exchanger: Stainless steel coil, instant heat transfer Solid-state technology, long life monitoring system controls heating operation (sensing Circuit Board: within 1º...
  • Page 8 PARTS LIST revised 11/13 BODY ASSY D - 2 PB111 - 56041875 1/10...
  • Page 9 Hose Clamp Ss 1-13/16 X 2-3/4 FP247 Repair Kit PB111 Heat System SUB459 Louver 2-1/2 Grey Plastic W/ FP440 Body Black Ultimate PB111 DRIL (models PB111-120, PB111-120-SS, PB111-240) ULT-GRN Body Green (model PB111-120-SP) ULT-TEAL Body For Pb111 Teal (model PB111-120-S) ULT-RED...
  • Page 10 PARTS LIST revised 6/12 CASTER PLATE ASSY Item Ref. No. Description FP137 Caster Plate Complete PB3 & Washer Lock External Tooth Washer-Flat-Al-3-16 NOTE 1 Rivet, 3/16” Aluminum 1/8”X 3/8” Grip NOTE 1 29USP Screw 1/4-20 X 1/2 Hwh Sl Caster For Ultimate Chrome NOTE 1 Caster Plate Plastic Polypropi NOTE 1 SUB928 Louver 3 Grey Plastic Include...
  • Page 11 revised 6/12 PARTS LIST HEAT SINK PLATE ASSY Item Ref. No. Description Bolt Hex 1/4-20 X 3/4 Full Nut-Nylock-Zp-1-4-20 Washer Flat 3/16 Zinc Plat Nut Nylon Lock 6/32 Z.P. Grommet 1 Id For A Hole 1 Screw-Php-Ss-Zp-6-32x3/4-Ms Plate Heat Sink Circuit Board 120 V Solvent (all models except PB111-240) Circuit Board Solvent Sense (model PB111-240) 138A...
  • Page 12 Pump & Motor PB111 240V No Me (model PB111-240 / includes 1, 2, 12) 435B Pump Slide Bracket Male SUB405 Pump Head Brass For Pb111-120 56478523 Tie-Cable FP148 Pump & Motor PB111 120V With (all models except PB111-240 / includes all items shown except 3, 8 & 10) FP185 Pump &...
  • Page 13 revised 6/12 PARTS LIST LIFT OUT BUCKET ASSY Item Ref. No. Description FP147 Bucket Lift-Out/PB111 Comple Nut-Nylon Lock-Ss-10-32 Nut-Hex Nyl Loc Ss 4-40 Screw 4-40 X 1-1/8 Ms S/ Screw 10-32 X 5/8 Socket Washer-Flat-Ss-10 Screw-Bhs-Brass-10-32x3/8-Ms Bushing Zinc 4-40 X 1/2 Bushing Aluminum 10-32 X 1 Insert .531 X 1/4o.D.
  • Page 14 PARTS LIST revised 6/12 VACUUM CHAMBER ASSY D - 8 PB111 - 56041875 1/10...
  • Page 15 revised 6/12 PARTS LIST VACUUM CHAMBER ASSY Item Ref. No. Description Nut-Nylock-Zp-1-4-20 Washer Flat 3/16 Zinc Plat Washer Rubber Bunan 90 S Insert Brass 4-40 X 3/16 Bolt Hex 1/4-20 X 3-1/2 Nut-Ss-Zp-1/4-20 Washer-Slitlock-Ss-Zp-1/4 Vac Motor, 120v (all models except PB111-240) 407A Vacuum Motor 5.7 240 V 2- (model PB111-240) 26”...
  • Page 16: Solution Tank Assy

    PARTS LIST revised 6/12 SOLUTION TANK ASSY D - 10 PB111 - 56041875 1/10...
  • Page 17 Pin Stripe Black 1/4 Solid 15 FP143 Solvent Sense Probe PB3 4321B Label Caution Solvent 2X 3 4324 Label Patent 4803466 2X 1/ (all models except PB111-120-S, PB111-120-SP) [ ] = Not Shown 1/10 56041875 - PB111 D - 11...
  • Page 20 425-322-0133 / 800-257-7982 / FAX: 425-322-0136 11015 - 47th Ave. W. / Mukilteo, WA 98275 VISIT US AT: http://www.usproducts.com...

Table of Contents