Page 1
COBRA -300H ® EXTRACTOR 120V INFORMATION & OPERATING INSTRUCTIONS DO NOT OPERATE MACHINE UNTIL YOU HAVE READ ALL SECTIONS OF THIS INSTRUCTIONS IMPROPER USE OF THE MACHINE WILL VOID THE WARRANTY 1. Always use a defoamer when foaming occurs to prevent vacuum motor damage. 2.
IMPORTANT SAFETY INSTRUCTIONS This machine is only suitable for commercial use, for example in hotels, schools, hospitals, factories, shops and offices other than normal residential housekeeping purposes. When using any electrical appliance, basic precautions should always be followed, including the following: NOTE: Read all instructions before using this machine.
INSPECTION: Carefully unpack and inspect your COBRA-300H for shipping damage. Each machine is tested and inspected before shipping. Any shipping damage incurred is the responsibility of the carrier. You should notify the carrier immediately if you notice damage to the box or to the machine or...
Page 4
CIRCUIT LOCATOR UPHOLSTERY PUMP VAC 1 BYPASS CARPET VACUUM (1), PUMP (2)SWITCHES: These switches are powered by cord #1. Switches are on when illuminated. CARPET/UPHOLSTERY SWITCH (3): This switch is also powered by cord #1. The carpet setting (down position) is high pressure (approximately 300 PSI).
Page 5
SET-UP: Fill the holding tank with clear water and the detergent of your choice. Mix well. Although this machine is designed to supply instant hot water, the addition of warm (not exceeding 130º F/54º C) to the holding tank would efficiency of the heater. Plug in cord #1.
TROUBLE SHOOTING: IF THIS OCCURS CHECK THIS NO SPRAY Solution tank is empty. Clogged spray tip. Pump not running. Valve on wand not operating. No power to pump. Test the switch. PUMP DOEN’T RUN Test the motor directly to AC power. Debris plugging cleaning tool or vacuum hose.