Table of Contents
Advertisement
Chapter 9.0 Using Z-Wave Devices
9.4 Controller Learn Mode
You can set the panel to receive network information from another Z-Wave controller using the
Learn Mode. P ress the button on the controller to put it into Learn Mode.
Some applications include adding the panel to or removing it from another network and changing
primary controllers.
9.5 Changing the Primary Controller
If there are two or more controllers in the Z-Wave network, you can change the primary controller
from the IoTega panel to another.
To do this, click Change Primary Controller under the Tools tab., then set the other controller to
Learn Mode. Refer to the controller manual for more information..
9.6 Adding a Device
The Smartlink user app main screen has different options to add and control Z-Wave devices.
To add a device on the app, tap the applicable option and complete the following steps:
1.
Power up your device per the manufacturer's instructions.
2.
From the Settings screen, tap Add Z-Wave Device to initialize learn mode.
3.
Follow the instructions onscreen to bind your device. R efer to the device instructions, if neces-
sary.
4.
When enrollment completes, enter a device name and tap OK. Your device is ready to use.
If using a Z-Wave smart switch to control power to a light or appliance, such as a fan, simply, plug
it into an AC power outlet.
Note: Only use the dimmer function on supported devices to prevent damage to the device.
9.6.1 Editing or Removing a Device
To edit or remove a device, complete the following steps:
1.
From the Settings screen, tap Edit Device, then select the device you want to edit or remove.
2.
Update the device name and tap Done to save your changes. Alternatively, tap Remove
Device to remove it from your system.
9.7 Device Interoperability
Your dealer can provide you with a list of currently supported Z-Wave devices. However, all Z-
Wave Plus devices, supported and unsupported, are partially or fully operable. At a minimum, listen-
ing nodes function as message repeaters.
9.8 Z-Wave Association Groups
The IoTega panel supports association group 1 with up to 100 nodes. A ssociation group 1 notifies
associated nodes of the device status. The panel sends a Z-Wave Basic Report as a bitmap with the
following property values:
Bit
Property
0
Low Battery
1
AC Failure
- 29 -
Hide quick links:
Advertisement
Table of Contents
