Alarm Memory - DSC IoTega User Manual

Chapter 10.0 Viewing Troubles on the Integrated Keypad
Top Level
Device Type
04 Keypad
05 Repeater
06 Wireless key
07 Communication

10.1 Alarm Memory

When an alarm occurs while the system is armed, it is stored in the alarm memory when you disarm
the system. T he system sounds a different tone than normal during entry delay. A fter disarming the
system, the zone number on the keypad flashes for 5 minutes to indicate an alarm in memory.
Note: If disarming the system with a 2-way wireless key, the system squawks three times to indic-
ate an alarm in memory.
!
Proceed with caution, as an intruder can still be within the premises.
To arm the system again, wave your hand in front of the keypad. The zone numbers stop flashing
and you can then arm the system. The alarm memory clears the next time you arm and disarm the
system.
Second Level
Trouble Type
01 AC (Power G only)
02 Battery Trouble (Power G
only)
03 Tamper (Power G only)
04 Fault (supervision) ( Power G,
WiFi keypads)
05 Not Networked (Power G only)
01 AC
02 Battery Trouble
03 Tamper
04 Fault ( supervision)
05 Not Networked
06 RF Jam
01 For future use
02 Battery Trouble
03 Tamper
04 Fault (supervision)
05 Not Networked
01 Receiver not available
02 FTC Trouble
03 Receiver supervision trouble
04 Cellular Trouble
05 Ethernet/WiFi Trouble
06 Remote shutdown
- 32 -
Third Level
Device ID
1 to 4
1 to 8
1 to 32
1- receiver 1
2- receiver 2
3- receiver 3
4- receiver 4