Charging With Ac Adaptor - Projecta HP2012 HP2200 User Manual

CHARGING WITH AC ADAPTOR

IMPORTANT: DO NOT POWER ANY APPLIANCE FROM THE JUMPSTARTER WHILE
IT IS BEING CHARGED USING THE AC CHARGER.
1. To charge, rotate the switch on the back of the unit to ON AND CHARGING (HP2012)
or 12V AND CHARGING (HP2200).
2. Plug the output end of the AC charger into the charging socket (back of jumpstarter)
and connect the charger to a 240VAC outlet and turn ON.
3. The CHARGING LED will illuminate blue when charging & the FULL LED will illuminate
solid green when the jumpstarter is fully charged. The jumpstarter will automatically
stop charging and the jumpstarter will initiate maintenance charge mode keeping the
battery fully charged and ready for use without the risk of overcharging.
Charging time: 15 hours if the battery is completely flat.
WHEN TO CHARGE
Your jumpstarter is shipped fully charged, however, an extended period of time may
elapse in shipment or storage before the jumpstarter is purchased. Therefore you
should charge the jumpstarter before using it for the first time. It is recommended to
charge fully after each use. If the jumpstarter is not being used, it is recommended
to leave the jumpstarter permanently on charge ensuring the battery is always
maintained fully charged and ready for use.
10