Charging With Ac Adaptor; When To Charge - Projecta HP900 User Manual

CHARGING WITH AC ADAPTOR

IMPORTANT: DO NOT POWER ANY APPLIANCE FROM THE JUMPSTARTER WHILE
IT IS BEING CHARGED USING THE AC CHARGER.
1. To charge, plug the output end of the AC Charger into the charging socket (back of
jumpstarter) and connect the Charger to a 240VAC outlet and turn 'ON'.
2. The charging LED will illuminate red when charging and green when the jumpstarter
is fully charged. The jumpstarter will automatically stop charging and the jumpstarter
will initiate maintenance charge mode keeping the battery fully charged and ready for
use without the risk of overcharging.
Charging time: 20–30 hours if the battery is down to 50% of its capacity.

WHEN TO CHARGE

Your jumpstarter is shipped fully charged, however, an extended period of time may
elapse in shipment or storage before the jumpstarter is purchased. Therefore you should
charge the jumpstarter before using it for the first time.
To prolong the life of your jumpstarter battery it is recommended to charge the
jumpstarter after each use. If the jumpstarter is not being used, it is recommended to
leave the jumpstarter permanently on charge ensuring the battery is always maintained
fully charged and ready for use.
7