Overrides - Lutron Electronics LCP128 Setup And Maintenance Manual

Overrides

Overview
From time to time, you may need to temporarily override the programmed settings for your system (for example,
to raise or lower the lights in a single circuit).
The LCP128 controller enables you to perform the following types of overrides:
• Circuit Level Override - Directly set a level for a dimming circuit or turn any circuit on or off. The override
occurs immediately and remains in effect as long as the Set Circuit Levels screen is displayed on the controller
LCD. Pressing Done to exit the Set Circuit Levels screen keeps the circuits at the override setting until they
are changed by a control station input or time clock event. Pressing Cancel to exit the Set Circuit Levels
screen returns the lights to their previous state.
• Scene Override - Directly apply circuit settings using a different scene. The override occurs immediately and
remains in effect as long as the Select Scene screen is displayed on the controller. Pressing Done to exit the
Select Scene screen keeps the circuits at the override setting until they are changed by a control station input
or time clock event. Pressing Cancel to exit the Select Scene screen returns the lights to their previous state.
• Time Clock Override - Enable or disable all time clock events. When the time clock is re-enabled, missed
events do not occur; control starts with the next scheduled event.
• Control Station Override - Enable or disable all control stations. When control stations are re-enabled, button
presses, key turns, and contact closures are processed again.
• Afterhours Override - Ends afterhours mode until it is re-started by the time clock.
Note: All override options are available from the master panel. Circuit level overrides are also available from
remote panels.
R
LCP128 Setup and Maintenance Guide
TM
49