Prog (Program) - LSI M-Three Operator's Manual

If option P is selected, the prompt message 'ENTER AMBIGUOUS
FILE NAME' will appear. Enter filename as prompted, depress the
RETURN key and proceed as for option R.
When the diskette is in place and the Space bar has been depressed,
the filename of the file being copied will be listed below the prompt
messages.
If the backup diskette that is being copied to runs out of storage
space before a file has been completely copied (options B or S),
the operator will be prompted to exchange the full diskette with a
'blank' one. The program will then copy the remainder of the file
onto the newly inserted diskette.
In the event of a file corruption on the source disk, the Backup
program will be used to restore the original information to the
Winchester disk (options P or R). The operator will be prompted
when to insert each backup diskette in turn if more than one is
required. Care must be taken to load the backup diskettes in the
correct order so that files which have been split are reloaded
properly.
6.6 PROG (Program)
As mentioned in 3.4, the keyboard's function keys can be program-
med to generate any desired code, or code sequence, when they are
depressed. This programming is handled by PROG.
N.B. There are
208
(DOH) codes available to the function keys and
although they do not have to be shared equally, a complex sequence
for one key will deprive the remainder.
To use the PROG program, proceed as follows:
a) Insert a diskette with the PROG program on it into either
disk drive.
b) Select the disk drive which contains the diskette with PROG
on it.
c) Key in PROG.
d) Depress the RETURN key.
6-6