Copydisc - LSI M-Three Operator's Manual

e) Remove the diskette with the VERI FY program on it.
t)
I nsert the diskette to be verified into the required disk drive.
g) Enter selection as prompted and depress the RETURN key.
As each track on the diskette is bing verified its number is displayed
(e.g. OOH - 4CH for 8" diskettes). If an error is detected, the track
and sector number is displayed along with the error-type; READ,
WRITE or COMPARE.
When the diskette verification is complete, a 'VERIFY
COMPLETED' message and either a 'NO VERIFY ERRORS WERE
DETECTED' or 'VERIFY ERRORS WERE DETECTED' message
will be displayed. These will be followed by the 'menu'. If another
diskette is to be verified then remove the verified diskette and
replace it with another blank diskette before making a further
selection. To 'exit' from VERIFY, replace the diskette with VERIFY
on it onto drive A (if necessary), key in E as prompted and then
depress the RETURN key.
6.4 COPYDISC
This program enables the operator to copy the Operating System
track (or tracks) only, the data tracks only, or all tracks from a
system diskette to a formatted and verified diskette.
To use the Copydisc program, proceed as follows:
a) Insert a diskette with the COPYDISC program on It Into
either disk drive (if this diskette contains the source material
then insert it into drive A).
b) Select the disk drive which contains the diskette with
COPYDISC on it.
c) Key in COPYDISC.
d) Depress the RETURN key.
6-3