Set Up An Ipv6 Internet Connection - TP-Link TL-WR1043N User Manual

Tips:
• If your Internet connection type is
your router.
• If you use Dynamic IP
on the page, please go to
• If you still cannot access the Internet, refer to the
4. 3.

Set Up an IPv6 Internet Connection

Your ISP provides information about one of the following IPv6 Internet connection types:
PPPoE, Dynamic IP(SLAAC/DHCPv6), Static IP, 6to4 tunnel, Pass-Through (Bridge).
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to Advanced > IPv6.
3. Enable IPv6 and select the Internet connection type provided by your ISP.
Tips:
If you do not know what your Internet connection type is, contact your ISP or judge according to the already known
information provided by your ISP.
4. Fill in information as required by different connection types. Red blanks must be filled
in.
1 ) Static IP: Fill in blanks and click Save.
2 ) Dynamic IP(SLAAC/DHCPv6):
your ISP requires. Click
BigPond Cable, please go to
and PPPoE and you are provided with any other parameters that are not required
Advanced > Network
Click
Save and then click Renew.
Advanced
> Internet to complete the configuration.
FAQ for further instructions.
Advanced to input further information if
> Network > Internet to set
17