Table of Contents
Advertisement
Tips:
• If your Internet connection type is
your router.
• If you use
Dynamic IP
on the page, please go to
• If you still cannot access the Internet, refer to the
4. 3.
Set Up an IPv6 Internet Connection
Your ISP provides information about one of the following IPv6 Internet connection types:
PPPoE, Dynamic IP(SLAAC/DHCPv6), Static IP, 6to4 tunnel, Pass-Through (Bridge).
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to
Advanced
> IPv6.
3. Enable IPv6 and select the Internet connection type provided by your ISP.
Tips:
If you do not know what your Internet connection type is, contact your ISP or judge according to the already known
information provided by your ISP.
4. Fill in information as required by different connection types. Red blanks must be filled
in.
1 )
Static IP:
Fill in blanks and click Save.
2 )
Dynamic IP(SLAAC/DHCPv6):
your ISP requires. Click
BigPond
Cable, please go to
and
PPPoE
and you are provided with any other parameters that are not required
Advanced
>
Network
Click
Save
and then click Renew.
Advanced
>
Internet
to complete the configuration.
FAQ
for further instructions.
Advanced
to input further information if
>
Network
>
Internet
to set
17
Advertisement
Table of Contents
