Table of Contents
Advertisement
Mounting
There are two untapped mounting holes and three locating aides on the top surface of the chassis.
Additionally, there are two untapped mounting holes and two locating aides on the bottom surface of the
chassis. The SE3300 can be mounted in any orientation without degradation in performance. See
NOTE Mounting the SE3300 in a non-upright position results in images rotated accordingly in snapshot mode.
Installation requires #2-32 thread-cutting screws with a maximum engagement depth of 5.5 mm.
Recommended mounting screw torque is 3.5 in-lb.
Notes: Unless otherwise specified:
•
Holes marked "B" are mounting holes. Holes marked "A" and slots marked "C" are imager engine locating aides.
•
This is a reference drawing and is not intended to specify or guarantee all possible integration requirements for this engine.
•
All untoleranced dimensions follow a general tolerance of +/- 0.15 mm.
SE3300 Mounting Diagram
Figure 2-1
See
Table 2-1
Installation
2 - 3
Figure
2-1.
Advertisement
Table of Contents
