Configuring The Digital Imager Scanner; Mounting The Digital Imager Scanner; Desk Mount - Motorola Symbol DS6707 Product Reference Manual

Removing the Interface Cable for Scanner with Base
Turn both angle adjustment knobs left to loosen the scanner in the base.
1.
Move the scanner forward until there is full access to the cable interface port on the bottom of the scanner.
2.
Using the tip of a screwdriver, depress the cable's modular connector clip. See
3.
Carefully slide out the cable.
4.
Follow the steps for
5.
Move the scanner to preferred angle and turn the angle adjustment knobs right to tighten.
6.

Configuring the Digital Imager Scanner

To configure the digital imager scanner, use the bar codes in this manual, or the 123Scan
See Chapter 4, User Preferences & Miscellaneous Digital Imager Scanner Options
Preferences for information about programming the digital imager scanner using bar code menus. Also see each
host-specific chapter to set up connection to a specific host type.
See Chapter 9, 123Scan2
1.
program includes a help file.

Mounting the Digital Imager Scanner

Desk Mount

Use the optional desk mount for convenient and protective placement of the digital imager scanner on a flat
surface. Simply place the mount on the surface. The rubber feet hold the mount securely in place when inserting
and removing the digital imager scanner.
Inserting the Digital Imager Scanner in the Desk Mount
Figure 1-6
Alternatively, secure the desk mount to a desk surface by inserting two screws* appropriate for the mounting
surface through the screw holes of the desk mount, and into the surface. Screw the desk mount onto the surface
with or without the rubber feet.
*The recommended screws are two #6 screws (5/8" long).
Installing the Interface Cable
to configure the digital imager scanner using this configuration program. The
SeeFigure
to connect a new cable.
Getting Started
1-5.
Figure 1-4.
2
configuration program.
and Chapter 6, Imaging
1 - 5