Table of Contents
Advertisement
CHAPTER 5 CONTROL INTERFACE
Introduction
The SE3300 bi-directional control interface uses the industry-standard I
host-initiated command/response type protocol, and does not support unsolicited responses.
Command List
The SE3300 protocol supports the commands listed in
Descriptions on page
SE3300 Command List
Table 5-1
2
I
C Command Set
ACQUISITION
ACQUISITION_MODE
AIM
AIM_BLINK_RATE
AIM_DURING_EXPOSURE
AIM_POWER
AUTO_POWER_REDUCTION
ENTER_BOOTLOADER
EXEC_INLINE
EXECUTE_SCRIPT
EXTERNAL_ILLUMINATION
FRAME_RATE
GET_FSTATS
5-5.
Opcode
0x58
0x5B
0x55
0xF4
0x56
0xF3
0x74
0x91
0x83
0x77
0x5A
0x5E
0x81
2
C protocol. The SE3300 protocol is a
Table
5-1. For detail on each command, see
Description
Starts and stops image data output.
Optimizes the SE3300 for a specific operation.
Turns the aim pattern on and off.
Controls the blink rate of the aim pattern.
Captures the aim pattern in the image.
Controls the brightness of the aim pattern.
Places the SE3300 in a low power state when idle.
Enters bootloader mode.
Executes a programmed script.
Executes a programmed script.
Controls the operation of the EXT_ILLUM_EN signal.
Sets the SE3300 frame rate.
Gets information about the last captured frame.
Command
Advertisement
Table of Contents
