Table of Contents
Advertisement
Picklist in Level Trigger Mode Procedure
The system is initialized as follows:
•
The host sends the Aim Off command.
•
The host sends the Illumination Off command.
•
The host sends the Acquisition Stop command.
•
The host sends the Barcode Decode mode command.
•
The host sends the Picklist Mode(1,60) command
•
The SE3300 optimizes the image output for bar code decoding.
•
The SE3300 enters standby mode (or low power mode if enabled).
Upon a trigger pull:
•
The host sends the Illumination On command.
•
The SE3300 exits standby mode (or low power mode if enabled).
•
The host sends the Aim On command.
•
The host sends the Acquisition Start command.
•
The SE3300 begins outputting images. Starting with the first frame, every 60th frame is a picklist frame
(1,61,121,181 ...).
•
The host attempts to decode the images.
Upon a good decode or trigger release:
•
The host sends the Acquisition Stop command.
•
The SE3300 stops outputting images.
•
The host sends the Aim Off command.
•
The host sends the Illumination Off command.
•
The SE3300 enters standby mode (or low power mode if enabled).
Application Notes
6 - 5
Advertisement
Table of Contents
