Emptying The Water Tank - Electrolux EOB6631 User Manual

10 www.electrolux.com
5.8 Steam Cooking
1. Set the function
2. Press the cover of the water drawer to
open it. Fill the water drawer with
water until the Tank Full indicator
comes on.
The maximum capacity of the tank is
900 ml. It is sufficient for
approximately 55 - 60 minutes of
cooking.
Use only water as the
liquid. Do not use filtered
(demineralised) or distilled
water. Do not use other
liquids.
Do not put flammable or
alcoholic liquids (grappa,
whisky, cognac, etc.) into
the water drawer.
3. Push the water drawer into its initial
position.
4. Prepare the food in the correct
cookware.
5. Set the temperature between 130 °C
and 230 °C.
Steam cooking does not give good
results in temperatures above 230 °C.
WARNING!
Wait a minimum of 60
minutes after each use of the
steam function in order to
prevent hot water from exiting
the water outlet valve.
Empty the water tank after the steam
cooking is completed.
CAUTION!
The appliance is hot. There is
a risk of burns. Be careful
when you empty the water
drawer.
5.9 Water tank indicator
When the steam cooking operates, the
display shows water tank indicator. Water
tank indicator shows the level of the water
in the tank.
• - Water tank is full. An acoustic
signal sounds when the tank is full.
Press any button to stop the acoustic
signal.
.
• - Water tank is half full.
• - Water tank is empty. An acoustic
signal sounds when the tank must be
refilled.
If you put too much water
into the tank, the safety outlet
moves the excess water to
the bottom of the oven.
Remove the water with a
sponge or a cloth.

5.10 Emptying the water tank

CAUTION!
Make sure that the appliance
is cool before you start to
empty the water tank.
1. Prepare the draining pipe (C), included
in the same package with the user
manual. Put the connector (B) onto
one of the ends of the draining pipe.
2. Put the second end of the draining
pipe (C) into a container. Put it at a
lower position than the outlet valve (A).
A
B
C
3. Open the oven door and put the
connector (B) into the outlet valve (A).
4. Push the connector again and again
when you empty the water tank.
The water tank can have
some water when the
display shows
symbol. Wait until the
water flow from the water
outlet valve stops.
5. Remove the connector from the valve
when the water stops flowing.