Jaw Replacement - Cembre B54MD-D6 Operation And Maintenance Manual

2
2.8) "W" style crimping dies assembles
– Press pins (2) and insert "W" dies into their
seats (see Fig. 4).
– To disassemble them simply press the pins and
slip them from the jaws.
2
FIG. 4

2.9) Jaw replacement

The tool is supplied with the interchangeable CDD 6 jaw.
Other types of jaw can also be supplied separately, for
replacement proceed as follows:
– Push and turn clockwise the locking pin (9) so that
the jaws are released.
– Slide the jaws out of the top of the tool and insert the
new ones (see Fig. 5).
– Fully insert the locking pin (9) into the tool and lock it
by turning clockwise until the red lines are aligned.
FIG. 5
I
T IS RECOMMENDED TO USE THE TOOL ONLY
WITH PRODUCT TO BE CRIMPED INSERTED
.
red lines
9
6