4.1.6 Cleaning the wiper
Be sure to read and understand the safety warnings before handling the printer.
(1) Cleaning time
Clean the wiper once a week or when blurs or incompleteness in printing remains after the head cleaning.
Notes
•
Use the poly-knit wiper when cleaning the wiper.
If the printer is switched ON, make sure that:
Step 0 :
•
Printing or other operations are not in progress.
•
The display on the operation panel is in the normal state.
Display the CR Maintenance menu on the operation panel.
Step 0 :
Press the [Menu] key on the operation panel.
Step 0 :
•
"Menu 1: Setup>" is displayed on the operation panel.
•
The operation panel shifts to the setup menu display.
Press the [>] key on the operation panel.
Step 0 :
•
"Set1: MediaType" is displayed on the operation panel.
Press the [+] key or [-] key to select "Set20: CR Maintenance".
Step 0 :
Press the [ENTER] key on the operation panel.
Step 0 :
•
"CR Mainte.: Start" is displayed on the operation panel
•
The display enters the CR Maintenance menu.
Press the [ENTER] key on the operation panel.
Step 0 :
•
Maintenance starts.
•
The print head moves to the left.
•
The wiper moves forward.
•
"CR Maintenance: End" is displayed on the operation panel.
52
Operation Instructions VJ-1604
AP-75769 - Revision 1.0 –2/04/2007
English