Assembling The Stand; The Stand Assembling Procedure; Detaching Protective Materials - MUTOH VJ-1204 Installation Manual

3 Assembling
Procedures for assembling this product are explained.
CAUTION
Make sure to unpack this product with
three persons or more.
3.1

The stand assembling procedure

If you will use the stand, assemble it in accordance
with the following steps.
1. Follow the steps shown below to assemble the
right side of the stand.
a. Attach the right support to the caster section.
b. Fasten two hexagon socket head cap screws
with the enclosed hexagonal wrench.
1
2
4
No. Name No.
1 Right support 4 Hexagon socket head cap
2 Caster lock
3 Caster section
2. Assemble the left side of the stand in a similar
way to step 1.
1
2
4
No. Name No.
1 Left support 4 Hexagon socket head cap
2 Caster lock
3 Caster section
3. Follow the steps shown below to attach the cen-
tral beam to the legs (left, right).
a. Attach the central beam and four hexagon socket
head cap screws to the stand (the left, the right).
b. Fasten the hexagon socket head cap screws with
the enclosed hexagonal wrench, and fasten the
central beam.
2
1
4
No. Name No.
1 Central beam 4 Hexagon socket head cap
2 Leg (left)
3 Leg (right)
4. Attach the book holder to the right side of the stand.
No.
1 Leg (right)
5. Confirm that each component is fastened firmly
by gently shaking the stand.

3.2 Assembling the stand

Attach the stand to the printer in accordance with the
following steps.
1. Lock two casters on the front side.
3
Name
No.
screws
1
2. Hold the following positions when lifting the prod-
uct.
Panel side:
Opposed side: two rubber grips under the product
NOTE
Make sure to hold the specified positions when lift-
ing the product.
This prevents the product from being fallen and
3
broken.
Do not hold the media guide. This may affect the
accuracy and correct operation of the product.
Name
screws
4
2
3
3
No.
1
4
2 Rubber grips
Name
screws
Name No. Name
2 Book holder
1
2
Name No. Name
Casters 2 Caster locks
two grips under the product
4
1
1
3
Name No. Name
Grips 3 Rubber leg tips
4 Media guide
3
VJ-1204 INSTALLATION MANUAL
3. Place the product on the stand so that the rear rub-
ber leg tips fit into the holes on the stand.
1
2
2
No. Name
1 Printer main body
4. Attach two butterfly bolts to the stand.
5. Secure the plotter to the stand by bolting the butter-
fly bolts.
1
No. Name
1 Butterfly bolts
This completes assembling of the stand.

3.3 Detaching protective materials

This product has protective materials in the place
shown below.
Detach all protective materials in accordance with the
following steps.
1. Remove all tapes from each cover.
2. Open the front cover and unscrew the butterfly
screws, and detach the fixing head unit protective
materials (metal plate).
1
No. Name
1 Fixing head unit protective
materials (metal plate)
This completes detaching protective materials.
1
2
No. Name
2 Holes on the stand
1
2
No. Name
2 Butterfly screw
VJ1204E-I-00