Operation - HAKO Citymaster 1600 Operating Manual

Attachments and Options
6.2.4

Operation

Checklist – Before start-up of the mowing system
No. Description
1 Checking transport protection device
2 Adjusting the cutting height
3 Preparing the dirt hopper
4 Checking and if necessary changing the mowing blades and V-belt
A
Fig. 157:
Fig. 158:
162
Checking the transport protection device
The transport protection device is located on the left side of the mower.
B
The mower is set for the relevant operation with the mounting bolt
Fig. 157-A. The following settings are possible:
Mowing: Take the mounting bolt out from the mounting position, see the
•
C
illustration (the mower must float freely).
Transport: The mounting bolt must secure the mower in the upper
•
position Fig. 157-B.
Cleaning: The mounting bolt must secure the mower in the lower
•
position Fig. 157-C.
Adjusting the cutting height
1. Place the vehicle on a level surface and hold it with the parking brake.
A
Raise the mower with the joystick Fig. 160-70. Switch the engine off
and pull out the ignition key.
2. Pull the mounting bolt Fig. 158-C out and push the bolt Fig. 158-A of
B
the wheel fork into the bush Fig. 158-B of the wheel spar until the
wanted cutting height is set. You can adjust the cutting height centime-
tre by centimetre with the two mounting holes in the bush.
C
3. You can read off the cutting height on the scale Fig. 158-D.
4. Secure the set cutting height with the mounting bolt.
D
Preparing the dirt hopper
Note
The setting of the cutting height must be the same for all
wheels.
If the grass is very long and wet, you are recommended firstly
to cut high and then to cut low once again.
Note
Mowing without circulating water! Lock the sump valve, see
page 145.
Reference
Page 162
Page 162
Page 162
Page 168
06-1491-00-12.fm