Paper; Paper Specification - Star SM-L304 Series User Manual

5. Paper

5.1 Paper Specification

 Receipt thermal Paper
Paper Width (W1)
Paper Thickness
Roll Paper Diameter
Recording side
Maximum Roll Diameter (D)
Curling dimension (W2)
Axial
NOTES: Do not use roll paper whose end is glued to its core, because the printer will be
unable to properly detect the end of the paper. Also, we recommend that you use
roll paper that has a roll end mark at its end.
(1)Operating
a) Temperature : 0 to 50 degrees
b) Humidity : 20 to 85 % RH (Must be no condensation)
*1 The combination of 50 degrees and 85% RH (No condensation) is considered the worst value
regarding high temperature and humidity. A higher humidity level higher than 80% combined with a
higher temperature can cause a problem if over a prolonged period of time (more than 4 hours).
(2)Transport / Storage
a) Temperature : -20 to 70 degrees
b) Humidity : 5 to 95 % RH (No condensation)
*1 This is a recommended storage range for temperature and humidity.
However, the storage condition could be the same as the operating condition provided the
recommended humidity level is not exceeded over a prolonged period of time (more than 4
hours).
If the storage condition does exceed the 4 hour period at the higher temperature/humidity
condition, we would recommend the rolls be in operating ambient conditions for two hours to
acclimate to the normal operating range.
39.5±0.5mm to 79.5±0.5mm (2mm pitch)
53μm to 85μm
12±1mm≤Ø≤18±1mm
Outside of roll
Ø57 mm
40+0.5-1 to 80+0.5-1 mm
Inner diameter Ø12±1 mm
Outer diameter Ø18±1 mm