Hardware Installation; Installation Instructions; Precautions - Extreme Networks AP-7622 Installation Manual

2

Installation Instructions

An AP-7622 Access Point mounts either on a wall or on a suspended ceiling T-Bar. To
prepare for the installation:
To prepare for the installation:
1 Match the part number on the purchase order with the part numbers in the packing list
and on the case of the Access Point.
2 Verify the contents of the box include the intended AP-7622 Access Point, and the
included hardware matches the package contents.
Part Number
AP-7622-68B30-US
AP-7622-68B30-1-WR
3 Review site survey and network analysis reports to determine the location and mounting
position for the AP-7622 Access Point.
4 Connect a CAT-5 or better Ethernet cable to a compatible 802.3at or 802.3af power
source and run the cable to the installation site. Ensure there is sufficient slack on the
cable to perform the installation steps.
NOTE
When operating in a Gigabit Ethernet environment, CAT-5e or CAT-6 cable is
recommended for Gigabit operation.

Precautions

Before installing an AP-7622 Access Point, verify the following:
• You are using the correctly rated power solution for the AP-7622 (either the power
injector or the external power supply)
AP-PSBIAS-2P3-ATR
PWR SPLY:100-240 VAC, 12VDC, 1.0A min,
2.5mm barrel, center positive, maximum
operating temperature at least 40°C
• Do not to install the AP-7622 in wet or dusty areas.
• Verify the environment has a continuous temperature range between 32° F to 104° (0-
40°C).
• This product is intended for indoor use only.
AP-7622 Access Point Installation Guide

Hardware Installation

Description
802.11ac dual band radio 1x1; or single band radio 2x2, internal
antenna, BLE, 1xGE (US only)
802.11ac dual band radio 1x1; or single band radio 2x2, internal
antenna, BLE, 1xGE (WR)
PWR INJECTOR: SINGLE PORT HI-PWR 802.3AT
AC/DC Power Supply
5