Lock Function; Operation Guide - Sharp AY-X36RU Service Manual

● Under °F temperature display, the remote controller will display 46°F heating.

3. Lock function

Press "▲" and "▼" simultaneously to turn on or turn off lock function. When lock function is on, " " icon is displayed on remote
controller. If you operate the remote controller, the " " icon will blink three times without sending signal to the unit.
4. Temperature display switch over function
Under OFF status, press "▲" and "MODE" buttons simultaneously to switch temperature display between °C and °F.

Operation guide

1. Once power is connected, press "ON/OFF" button on remote controller to turn on the air conditioner.
2. Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN, HEAT.
3. Press "▲" or "▼" button to set your required temperature. (Temperature can't be adjusted under auto mode).
4. Press "FAN" button to set your required fan speed: auto, low, medium and high speed.5. Press "SWING" button to select fan
blowing angle.
Replacement of batteries in remote controller
1. Press the back side of remote controller marked with " ", as shown in the fig, and then
push out the cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the position of "+" polar and
"-" polar are correct.
3. Reinstall the cover of the battery box.
Note:
● During operation, point the remote control signal sender at the receiving window of the indoor unit.
● The distance between signal sender and receiving window should be no more than 8m, and there should be no obstacles between
them.
● Signal may be interfered easily in the room where there is fluorescent lamp or wireless telephone; remote controller should be close
to indoor unit during operation.
● Replace new batteries of the same model when replacement is required.
● When you don't use remote controller for a long time, please take out the batteries.
● If the display on remote controller is fuzzy or there's no display, please replace batteries.
9
AY-X36RU
AE-X36RU
Signal sender Battery
Reinstall
Remove
Cover of battery box