Sleep Button - Sharp AY-X36RU Service Manual

● When selecting heating mode, the air conditioner operates under heat mode. Heat indicator " " on indoor unit is ON. Press "▲"
or "▼" button to adjust set temperature. Press "FAN" button to adjust fan speed. Press "SWING" button to adjust fan blowing
angle. (Cooling only unit won't receive heating mode signal. If setting heat mode with remote controller, pressing ON/OFF button
can't start up the unit).
Note:
● To preven cold air after starting up in heating mode, indoor unit will delay 1~5 minutes to blow air (actual delay time is depend
on indoor ambient temperature).
● Set temperature range from remote controller: 16~30°C(61°F~86°F); Fan speed: auto, low speed, medium speed, high speed.
3. FAN button
Pressing this button can set fan speed circularly as: auto (AUTO), low (
Note:
● Under AUTO speed, air conditioner will select proper fan speed automatically.
● Fan speed under dry mode is low speed.
4. SWING button
Press this button can select up&down swing angle. Fan blow angle can be selected circularly as below:
● When selecting " ", air conditioner is blowing fan automatically. Horizontal louver will automatically swing up & down at
maximum angle.
● When selecting " ,
position.
● When selecting " ,
● Hold " "button above 2seconds to set your required swing angle. When reaching your required angle, release the button.
5. TURBO FAN button
Under COOL or HEAT mode, press this button to turn to quick COOL or quick HEAT mode. "
controller. Press this button again to exit TURBO FAN function and "
6. ▲/▼ button
● Press "▲" or "▼" button once increase or decrease set temperature 1°C(1~2°F). Holding "▲" or "▼" button, 2seconds later,
set temperature on remote controller will change quickly. On releasing button after setting is finished, temperature indicator on
indoor unit will change accordingly. (Temperature can't be adjusted under auto mode)
● When setting TIMER ON, TIMER OFF or CLOCK, press "▲" or "▼" button to adjust time. (Refer to CLOCK, TIMER ON, TIMER
OFF buttons) When setting TIMER ON, TIMER OFF or CLOCK, press "▲" or "▼" button to adjust time. (Refer to CLOCK,
TIMER ON, TIMER OFF buttons)

7. SLEEP button

Under COOL or HEAT mode, press this button to start up SLEEP function. "
button again to cancel SLEEP function and "
8. TEMP button
By pressing this button, the indoor set temperature, indoor ambient temperature or outdoor ambient temperature is shown on the
indoor unit's display. The setting on remote controller is selected circularly as below:
● When selecting " " or no display with remote controller, temperature indicator on indoor unit displays set temperature.
● When selecting " " with remote controller, temperature indicator on indoor unit displays indoor ambient temperature.
● When selecting " " with remote controller, temperature indicator on indoor unit displays outdoor ambient temperature.
Outdoor temperature display is not applicable for this unit. The temperature indicator displays indoor set temperature.
Note:
● It's defaulted to display set temperature when turning on the unit.There is no display in the remote controller.
● Only for the models whose indoor unit has dual-8 display.
● When the selecting display of indoor or outdoor ambient temperature, indoor temperature indicator displays corresponding
temperature and automatically turn to display set temperature after three or five seconds.
Auto
(horizontal louvers stops at current position)
, , , ", air conditioner is blowing fan at fixed position. Horizontal louver will stop at the fixed
, " , air conditioner is blowing fan automatically.
" icon will disappear.
), medium ( ), high (
" icon will disappear.
" icon is displayed on remote controller. Press this
7
AY-X36RU
AE-X36RU
).
" icon is displayed on remote