Stop And Start The Ds Storage Manager Servers; Stopping And Starting The Ds Storage Manager Servers On A Windows Operating System; Stopping And Starting The Ds Storage Manager Servers On A Linux Operating System - IBM DS8000 User Manual

Stop and start the DS Storage Manager Servers

The IBM System Storage DS Storage Manager server and IBM System Storage DS
Network server are installed and activated when you installed the DS Storage
Manager. These servers remain active until you stop them or there is a system
failure.
Each server is accessed by a different method depending on your operating
system.
Stopping and starting the DS Storage Manager servers on a
Windows operating system
You can stop or start the DS Storage Manager servers by using the Windows
Programs list.
Log on to your Windows operating system and use the following steps to work
with the DS Storage Manager servers. Perform these steps for each server.
1. Click Start.
2. Select Programs to display the programs list.
3. Click (IBM System Storage DS Storage Manager and then click Stop Servers or
4. Click Stop, or Start for the action that you want to complete.
Stopping and starting the DS Storage Manager servers on a
Linux operating system
You can type the following commands to check on the status of the servers and
then to stop or restart them on a Linux operating system.
Open a command prompt window and use the following commands to check
status and stop or start the servers. Notice that the DS Storage Manager server
stops first and then the DS Network Interface server stops. The servers start in the
opposite order.
1. Type /etc/init.d/dsStorageManagerServer status to see the status of the DS
2. Type /etc/init.d/dsStorageManagerServer stop to stop the DS Storage
3. Type /etc/init.d/dsStorageManagerServer start to start the DS Storage
4. Type /etc/init.d/dsnisrv status to see the status of the DS Network Interface
80
DS8000 User's Guide
– Use HTTP 1.1.
– Use HTTP 1.1 through proxy connections.
4. Click Apply.
5. Close and then reopen the browser.
6. You will now be able to access the IBM TotalStorage Productivity Center
GUI.
Start Servers depending on your choice of action. Wait for the servers to start
up or completely stop before proceeding. The DS Storage Manager server will
stop first and then the DS Network Interface server. The servers start in the
opposite order. They can be stopped and started separately, but they must
follow this order.
Storage Manager server.
Manager server.
Manager server.
server.