Standard Vs. Extended Position - Travis Industries Pro Builder42 Linear Installation Manual

16

Standard vs. Extended Position

There are two positions that the standoff/heat shield assembly can be installed. The standoffs are
shipped in the standard (forward) position.

If the unit is installed in the standard position no modification is needed.

If the unit is being installed in the extended position, the standoff/heat shield assembly must
be repositioned back ½" (see illustration below).
NOTE: see pages 15 & 37.for additional details about standard vs. extended installations.
© Travis Industries
Installation
(for qualified installers only)
10/16/17 - 1453
Extended Position
Standard Position
PB 42 MV/GSB2 Install