Removing The Front Panel - Travis Industries Pro Builder42 Linear Installation Manual

Removing the Front Panel

The front cover may be removed to access the components. This is required when relocating the electrical or gas
inlet location. To remove the front cover
(a) Remove the center wingnuts.
(b) Loosen the two outer screws.
(c) Rotate the front panel down.
(d) Remove the front cover.
© Travis Industries
Installation
(for qualified installers only)
10/16/17 - 1453
23
1/4" Nutdriver/Wrench
PB 42 MV/GSB2 Install