Planet Networking & Communication ICS-100 User Manual page 43

Setup Operation Mode and Serial Port of ICS-10x
1. Set the ICS-10X mode to "Telnet server mode" from web interface.
2. Set the Serial Port Configuration of ICS-10x as below:
Mode:
Baudrare:
Character Bits:
Parity Type :
Stop Bit :
Hardware Flow Control:
Execute "Telnet" command from Windows Start Menu
3. Click the Start Menu and go to Run
4. Type "telnet" without the quotes, and hit enter.
5. While the Telnet window appears, type "open xxx,xxx,xxx,xxx", xxx is the IP address of the ICS-10x Telnet Server.
In this case we type "open
6. Then can use the telnet connection to configure the switch just like console direct connect to the COM port of the
switch.
RS-232
9600
8
none
1
none
Figure 4-40 Example Windows Excuse - Telnet
192.168.0.100" and press enter.
Figure 4-41 Example Windows Excuse - Telnet
-39-
User's Manual of ICS-10x