Planet Networking & Communication ICS-100 User Manual page 36

The page includes the following fields:
• TCP Port Number
• Inactive Timeout
Example: Use PLANET VCOM Utility + Microsoft Windows Hyper terminal COM
Port mode
The user want to use the virtual COM like to use the serial cable connect the switch.
1. Setup Operation Mode and Serial Port of ICS-10x
2. Use PLANET VCOM Utility to create virtual COM Port
3. Hyper Terminal set up a new connection with the virtual COM port
Setup Operation Mode and Serial Port of ICS-10x
1. From the WEB interface, set the Serial operation mode of ICS-10x to "Virtual COM" and set the TCP Port Number
to "23".
The TCP port that ICS-10X uses to listen to connections and that other device
must use to contact ICS-10X. To avoid conflicts with well known TCP ports, the
default is set to "1024".
Use the parameter to set an inactive timeout. The unit drops the connection if
there is no activity on the serial line before the set time expires. To disable the
inactive timeout enter "0".
Figure 4-27 Example Virtual COM Mode
-32-
User's Manual of ICS-10x