Necessary Tools - Factor O2 Assembly Manual

Torque wrench with 3, 4, 5mm hex & Torx T20 bits
BRT-002 bearing press from Enduro Bearings
Sand paper (120-180 grift)
Park Tool IR-1
Similar to a Formula 1 car, your Factor O2 requires a bit of patience and mechanical skill to achieve a truly impressive result.
We recommend that you have your bicycle assembled and maintained by an authorized Factor dealer. Make sure to let your
mechanic know how much you appreciate their help building the bike of your dreams!
Route the Di2 seat post cable from seat tube to the bottom
bracket (internal port). Connect to the Shimano Di2 Junction B
according to Shimano's instructions.

Necessary tools

Instructions
1-1
Seatpost
Marker
Hacksaw with carbon cutting saw blade
Grease & Loctite 243 & 641
Isopropyl alcohol
Check which rails standard are on your saddle.
Note: Factor frame sets are shipped with 7X9 mm outer rail
clamps for carbon rail saddles. 7x7 mm outer rail clamps for
traditional saddle rails are available through your Factor
dealer.
1-2
Adjust the set back and saddle angle to the desired
position. Tighten the M6 saddle clamp bolt to 15 Nm.
Assembly Manual
1-3
round 7x7 mm rails
oval 7x9 mm rails
01