Factor O2 Assembly Manual page 5

Place the battery holders around the Di2 battery. The male
shell grooves must match with the female battery groove.
Slide 4 mm hex wrench through the hole under the top tube
and use to guide the seat post wedge into position
1-4
1-7
Insert battery in the seat post.
Apply Black Inc Installation
Compound to the inside of the
seat tube. Connect the Di2
cable to the battery. Insert
seat post into the frame to the
desired height.
Note: Your Factor frame set requires a minimum of 90 mm of
seat post insertion. The minimum insertion is clearly marked
on the seat post. Failure to achieve the minimum insertion
could cause damage to the seat post or frame resulting in
serious injury or death.
1-5
1-8
Before assembly, the wedge must be adjusted so that
both bolts are flush with the outer surface of the
wedge (red line of the picture). Keep in mind that the
M4 bolt only holds the wedge pieces together and
plays no part in tightening the seat post.
Secure the seat post by tightening the M8 grub
screw to 6 Nm
Assembly Manual
1-6
1-9
02