Port Command - Planet VC-412 User Manual

VC-412 User's Manual
connected port of the VC-412 to the same speed. The reason you need to set the speed
on the remote modem first is when you adjusts the speed on the remote modem,
connection with end since speeds on both sides will be different. After setting the VC-412
port to the same speed as the remote modem, connection will re-establish if it is within
the distance limitation. For example if you want to test the quality of transmission with the
stream rate speed at speed level-B (5 Mbps symmetric). You will enter the following
commands in the ICD command interface.
RT 10-B
Connection will end
LT 10-B
Connection will re-establish if within the range.
If connection does not establish with new speed level, reset the switch and wait
approximately 47 seconds for the switch and the remote modem to recalibrate.

5.5 Port Command

The "P" command displays all the VDSL ports status including its speed and speed mode.
AUT represents Auto-speed mode, PRE represents preset speed and MAN represents
manual set speed. At the speed column you will see a representation of preset speed and
the current speed of each port. The numerator is preset speed ("*" means not applicable)
and the denominator is current speed. Please refer to the ICD Command Index table for
reference.
37