Planet VC-412 User Manual page 37

X
VLAN Command
V
VO
VF
VG <group>-<port>, ..., <port>
VG <group>
VDSL Command
LT <port>-<speed>
RT <port>-<speed>
LR <port>-<speed>
LR <port>-
SR <port>
Port Command
PC
PC <port>
C
C <port>
VDSL port Enable
Speed Mode = Auto Speed
To exit ICD command prompt
Show the current VLAN settings
*1
Set VLAN to ON
Set VLAN to OFF
Select the <port(s)> to belong to <group>
The available VLAN group number is from 1 to 16. Issue this
VG command will automatically switch the VLAN mode to
USER DEFINED.
Example: "VG 2-1,2,3,B" will create VLAN group 2 with
member ports:1,2,3 and B.
Empty VLAN Ports group
Set VDSL <port> to <speed> on local(LT) end
There are six speed levels to select from when
setting VDSL port speed. A, B, C, D is for
VC-101S firmware version R4.5.
firmware version R2 and Q is for firmware
version R4.
A: Downstream 4 Mbps/Upstream 1 Mbps (R4.5)
B: Downstream 5 Mbps/Upstream 5 Mbps (R4.5)
C: Downstream 11 Mbps/Upstream 11 Mbps (R4.5)
D: Downstream 15 Mbps/Upstream 17 Mbps (R4.5)
P: Downstream 11 Mbps/Upstream 11 Mbps (R2)
Q: Downstream 15 Mbps/Upstream 17 Mbps (R4)
Example: "LT 2-B" will configure local port 2's speed to
symmetric 5Mbps
Set VDSL <port> to <speed> on remote(RT) end
Set VDSL <port> to preset <speed>.
Please then issue S command if you want to save this
settings.
Set VDSL <port> to auto-speed
Save data on remote side of VDSL <port>
Show all counters for all ports
Show all counters for <port>
Clear all counters for all ports
Clear all counters for <port>
VC-412 User's Manual
P is for
33