Table of Contents
Advertisement
Removing the RackSwitch from a System x or Power rack
To remove the RackSwitch from a System x or Power rack, complete the following
steps:
1. Disconnect all cables.
2. Loosen and remove M3 screws that secure the rear brackets to the front
3. Loosen and remove M6 washers, screws, and clip nuts that attach the filler
4. Slide the rear mounting brackets out of the slots available on the front mounting
34
IBM System Networking RackSwitch G8332: Installation Guide
brackets.
10 11
plate (if present) to the rear mounting brackets.
8
brackets.
9
3
4
2
6
Advertisement
Table of Contents
