Removing And Replacing The Ac Power Supply Module; Removing The Ac Power Supply Module - IBM G8332 Installation Manual

Removing and replacing the AC power supply module

The RackSwitch operates with either one or two active AC power supply modules.
You can replace a hot-swap power supply module without powering off the switch or
disrupting switch functions.
Each AC power supply module has a power cord for connection to an AC power
outlet.
Each power supply module has three LEDs that are visible from the rear panel. The
following table describes the LEDs.

Removing the AC power supply module

To remove the AC power supply module, complete the following steps:
1. Remove the power cord from the power connector.
2. Press the release latch on the left side of the power supply module, and slide
36
IBM System Networking RackSwitch G8332: Installation Guide
9
Table 16. Power supply module LEDs
LED status
OK
Green
Off
Service ( ! )
Amber
Off
~ AC Input
Green
Off
the module out of the slot.
1
7
Description
DC output power is present.
DC output power is OK.
Power supply or fan module failure.
Power supply and fan modules are
operational.
AC power is OK.
No power. Output is disabled, or input power
is out of operating range.
9