Replacing the AC power supply module
DANGER
(L003)
To replace the AC power supply module, complete the following steps:
1. Insert the power supply module into the power-supply slot, and gently push it
2. Connect the power cord to the power supply module and to an AC power
3. Turn on the power at the power source.
4. Make sure that the power supply OK and AC LEDs are green.
Removing and replacing the fan module
The RackSwitch contains four hot-swap fan modules. All four fan modules are
required for normal operation.
Attention:
Do not leave the power-supply slot empty for more than 90
seconds while the switch is operating.
Multiple power cords. The product might be equipped with multiple power
cords. To remove all hazardous voltages, disconnect all power cords.
into the slot until it latches. Each power supply module has a mechanical guide
key to prevent you from inserting the module incorrectly.
source.
Chapter 3. Removing and replacing the RackSwitch and components
37