Table of Contents
Advertisement
DANGER
(L002)
Attention:
To install the RackSwitch in a standard 19-inch equipment rack, complete the
following steps:
1. Locate and record the product switch information to configure and register your
2. Use the M4 screws to attach a mounting bracket to each side of the switch.
3. Gently slide the switch into the rack.
4. Use the M6 screws, washers, and clip nuts (or cage nuts) to secure the switch
18
IBM System Networking RackSwitch G8332: Installation Guide
Rack-mounted devices are not to be used as shelves or work spaces.
For earthquake stability, mount the switch in a 4-post rack.
product and set aside. See "Before installing the RackSwitch" on page 13.
Note: If this switch is a replacement switch, copy the product information from
the original switch onto the RID label that is shipped with replacement
switch and affix the new label to the bottom of the new switch.
Torque the screws to approximately 2.0 newton-meters (Nm) +/- 0.1 Nm (17.7
inch-pounds).
unit to the rack. Torque the screws to approximately 5.7 Nm +/- 0.1 Nm (50
inch-pounds).
6
5
Advertisement
Table of Contents
