Login The Switch - Planet GSD-802S User Manual

The Gigabit Ethernet Switch must have an Internet Protocol (IP) address accessible for the remote host.

3.2.2 Login the Switch

Before you start configure the Gigabit Ethernet Switch, please note the Gigabit Ethernet Switch is configured through an
Ethernet connection, make sure the manager PC must be set on same the IP subnet address. For example, the default
IP address of the Gigabit Ethernet Switch is 192.168.0.100, then the manager PC should be set at 192.168.0.x (where x is
a number between 2 and 254), and the default subnet mask is 255.255.255.0. Use Internet Explorer 5.0 or above Web
browser. Enter IP address http://192.168.0.100 (the factory-default IP address) to access the Web interface.
When the following login screen appears, please enter the default password "admin" and press Login to enter the main
screen of Gigabit Ethernet Switch. The login screen in Figure 3-1 appears.
1.
Notice:
2.
Figure 3-1 Web Login screen of Gigabit Ethernet Switch
For security reason, please change and memorize the new password after this first setup.
Only accept command in lowercase letter under web interface.
User's Manual of GSD-800S / GSD-802S / GSD-802PS