Rstp Port Configuration - Planet GSD-802S User Manual

• Max Age -. The value lies between 6 and 40, with the value being less than or equal to "(2 *
Notice:
• Hello Time - The value being less than or equal to "(Bridge Max Age / 2) - 1". The default hello
• Forward Delay- Bridge Forward Delay must be greater or equal to "(Bridge Max Age / 2) + 1".

4.6.2 RSTP Port Configuration

The RSTP Port Configuration page contains fields for assigning RSTP properties to individual ports. The screen in Figure
4-25 appears.
The page includes the following fields:
• Port
• Edge
• Path Cost
stations, avoiding and eliminating loops.
Bridge Forward Delay) - 1" and greater than or equal to "2 * ( Bridge Hello Time +1)". The
default value is 20.
time value is 2.
The time range is from 4 seconds to 30 seconds. The default value is 15.
Figure 4-25 RSTP Port Configuration
Indicate port 1 to port 24.
Indicates whether the port is enabled as an edge port.
Edge port cannot create loops, but it loses edge port status if a topology change
creates a potential for a loop. An edge port normally should not receive BPDU
packets. If a BPDU packet is received it automatically loses edge port status.
The port contribution to the root path cost. The path cost is adjusted to a higher or
lower value, and is used to forward traffic when a path being rerouted.
Value Rage : 1-20000000.
Default Path Cost -- The default path cost of the port is automatically set by the
port speed and the default path cost method. The default values for path costs
are:
User's Manual of GSD-800S / GSD-802S / GSD-802PS