Table of Contents
Advertisement
TG2130_2132.book Page 26 Tuesday, July 11, 2006 11:06 AM
Useful Information
Troubleshooting
General use
Problem
The unit does not work.
I cannot hear a dial tone.
Programmable settings
Problem
While programming, the
handset starts to ring.
Battery recharge
Problem
I fully charged the battery,
but
continues to
display.
The handset display is
blank.
Making/answering calls, intercom
Problem
The handset does not
ring.
26
For assistance, please visit http://www.panasonic.com/phonehelp
Cause/solution
L Make sure the battery is installed correctly and fully
charged (page 8).
L Check the connections (page 7).
L Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
L Place the handset on the base unit and try again.
L Confirm the telephone line cord is properly connected
(page 7).
L Disconnect the unit from the telephone line and connect
a known working telephone. If the working telephone
operates properly, contact our service personnel to
have the unit repaired. If the working telephone does
not operate properly, contact your telephone service
provider.
Cause/solution
L A call is being received. Answer the call and start again
after hanging up.
Cause/solution
L Clean the charge contacts and charge again (page 9).
L The battery may need to be replaced with a new one
(page 8).
L Confirm that the battery is properly installed.
L Fully charge the battery (page 8).
Cause/solution
L The ringer is turned off. Turn it on (page 12).
Advertisement
Table of Contents
