Table of Contents
Advertisement
Error messages
Display message
Busy
Error!!
No link to base. Reconnect
main base AC adaptor.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit's
AC adaptor, then reconnect the base unit's AC adaptor. Remove the batteries from the handset,
and then insert the batteries into the handset again.
General use
Problem
The handset does not turn on
even after installing charged
batteries.
The unit does not work.
I cannot hear a dial tone.
TG422xC(en)_0122_ver011.pdf
Cause/solution
R The called unit is in use.
R Other units are in use and the system is busy. Try
again later.
R The handset you are using is too far from the base
unit. Move closer and try again.
R There is no handset registered to the base unit
matching the handset number you entered.
R Recording was too short. Try again.
R The handset has lost communication with the base
unit. Move closer to the base unit and try again.
R Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset's registration may have been cancelled.
Re-register the handset (page 34).
Cause/solution
R Place the handset on the base unit or charger to turn on
the handset.
R Make sure the batteries are installed correctly (page 8).
R Fully charge the batteries (page 8).
R Check the connections (page 8).
R Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset has not been registered to the base unit.
Register the handset (page 34).
R The base unit's AC adaptor or telephone line cord is not
connected. Check the connections.
R Disconnect the base unit from the telephone line and
connect the line to a known working telephone. If the
working telephone operates properly, contact our service
personnel to have the unit repaired. If the working
telephone does not operate properly, contact your service
provider/telephone company.
31
Useful Information
2013/01/22
11:22:42
31
Advertisement
Table of Contents
