Table of Contents
Advertisement
TG2130_2132.book Page 7 Tuesday, July 11, 2006 11:06 AM
Setting up the base unit
Connecting the AC adaptor and
telephone line cord
Connect the telephone line cord until it
clicks into the base unit and telephone
line jack. Connect the AC adaptor cord
by pressing the plug firmly.
L Use only the included Panasonic AC
adaptor
xxxx
or xxxx.
(120V AC,
60Hz)
Note:
L The AC adaptor must remain connected
at all times. (It is normal for the adaptor
to feel warm during use.)
L The AC adaptor should be connected to
a vertically oriented or floor-mounted AC
For assistance, please visit http://www.panasonic.com/phonehelp
L The unit will not work during a power
If you subscribe to a DSL service
Please attach a noise filter (contact your
DSL provider) to the telephone line
between the base unit and the telephone
line jack in the event of the following:
– Noise is heard during conversations.
– Caller ID features (page 18) do not
Hook
To single-line
telephone jack
(RJ11C)
outlet. Do not connect the AC adaptor to
a ceiling-mounted AC outlet, as the
weight of the adaptor may cause it to
become disconnected.
failure. We recommend connecting a
corded telephone to the same telephone
line or to the same telephone jack using
a Panasonic T-adaptor (page 3).
function properly.
Noise filter
Preparation
To single-line
telephone
jack (RJ11C)
7
Advertisement
Table of Contents
