Configuring Alarm Input - HIKVISION DS-2DP1636Z-D User Manual

6.1.4 Configuring Alarm Input

Steps:
1. Enter the Alarm Input settings interface:
Configuration > Event > Basic Event > Alarm Input
2. Choose the Alarm Input No. and the Alarm Type. The alarm type can be NO (Normally Open)
and NC (Normally Closed).
3. Edit the name in
input (optional).
4. Click
schedule configuration is the same as the setting of the arming schedule for motion detection.
Refer to Step 5 in Section 6.1.1 Configuring Motion Detection.
5. Click
Email, Notify Surveillance Center, Upload to FTP/Memory Card/NAS, Trigger Alarm Output and
Trigger Recording are selectable. Refer to Step 6 in Section 6.1.1 Configuring Motion
Detection.
6. You can also choose the PTZ linking for the alarm input. Check the relative checkbox and
select the No. to enable Preset Calling, Patrol Calling or Pattern Calling.
7. You can copy your settings to other alarm inputs.
8. Click
User Manual of PanoVu Series Network Camera
Figure 6-9 Alarm Input Settings
tab to enter the arming schedule setting interface. The arming
tab to select the linkage method taken for the video loss alarm. Send
to save the settings.
72
to set a name for the alarm