HIKVISION DS-2DP1636Z-D User Manual page 3

harmonized European standards listed under
the EMC Directive 2014/30/EU, the RoHS
Directive 2011/65/EU
2012/19/EU (WEEE directive): Products
marked with this symbol cannot be
disposed of as unsorted municipal waste
in the European Union. For proper
recycling, return this product to your
local supplier upon the purchase of
equivalent new equipment, or dispose of it at designated
collection points. For more information see:
www.recyclethis.info.
2006/66/EC (battery directive): This
product contains a battery that cannot
be disposed of as unsorted municipal
waste in the European Union. See the
product documentation for specific
battery information. The battery is marked with this
symbol, which may include lettering to indicate cadmium
(Cd), lead (Pb), or mercury (Hg). For proper recycling,
return the battery to your supplier or to a designated
collection point. For more information see:
www.recyclethis.info.
Industry Canada ICES-003 Compliance
This device meets the CAN ICES-3 (A)/NMB-3(A) standards
requirements.
Safety Instruction
These instructions are intended to ensure that the user can
use the product correctly to avoid danger or property loss.
The precaution measure is divided into 'Warnings' and
'Cautions':
Warnings: Serious injury or death may be caused if any of
these warnings are neglected.
Cautions: Injury or equipment damage may be caused if
any of these cautions are neglected.
Warnings
Follow these safeguards
to prevent serious injury or
death.
User Manual of PanoVu Series Network Camera
Cautions
Follow these precautions to
prevent potential injury or
material damage.
Warnings:

Please adopt the power adapter which can meet the
safety extra low voltage (SELV) standard. The power
consumption cannot be less than the required value.

Do not connect several devices to one power adapter
as an adapter overload may cause over-heating and
can be a fire hazard.

When the product is installed on a wall or ceiling, the
device should be firmly fixed.

To reduce the risk of fire or electrical shock, do not
expose the indoor used product to rain or moisture.
 This installation should be made by a qualified service
person and should conform to all the local codes.
 Please install blackouts equipment into the power
supply circuit for convenient supply interruption.
 If the product does not work properly, please contact
your dealer or the nearest service center. Never
attempt to disassemble the product yourself. (We shall
not assume any responsibility for problems caused by
unauthorized repair or maintenance.)

Please do not look directly into the laser light within 6
meters because laser is hazardous to humans.
Cautions:
 Make sure the power supply voltage is correct before
using the product.
 Do not drop the product or subject it to physical shock.
Do not install the product on vibratory surface or
places.
 Do not expose it to high electromagnetic radiating
environment.
 Do not aim the lens at the strong light such as sun or
incandescent lamp. The strong light can cause fatal
damage to the product.
 The sensor may be burned out by a laser beam, so
when any laser equipment is being used, make sure
that the surface of the sensor not be exposed to the
laser beam.
 For working temperature, please refer to the
specification manual for details.
 To avoid heat accumulation, good ventilation is
required for a proper operating environment.
 While shipping, the product should be packed in its
original packing.
ii